E5515C Iconfig File Extraction Instructions

Here is how you extract the Iconfig configuration file from the Agilent 8960 series if you currently own an E5515C and are looking to sell it or trade it in to us.

First you need to install the 8960 config reader. Click the link below to download.

QTUTSetup.zip

Then you need to plug the 8960 into your local LAN network port, or one of your router ports.

Then you need to give the 8960 an IP address, like 193.167.0.100 or whatever is not currently in use. Use the ‘setup’ and/or ‘config’ buttons until you find one that lets you edit the network settings.

You might have to put the subnet mask and the gateway settings too. in too. Just look at the network settings of whatever computers you are using there if you are not sure what those should be set to.

Example settings:

So you want the 8960 on your network on a different ip address.

Then you fire up the config software and type in the IP you had just put into the machine

Once you are connected, you want to click on ‘mode’ and then ‘open iconfig’

And you should be able to get the file from there.

The following two tabs change content below.
Mike is a finance industry executive with expertise in test, IT and avionics equipment acquisition, resale, residual valuation, leasing, renting and consignment.
This entry was posted in Applications. Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *


− five = 3

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>